Sheesh why didn't I think of that. Here's the only one I have and I stole this one from somebody else. After removal from the brass tumbler, to get residue and cleaning media off the brass the easy way I use a piece of fine wire mesh, (about 1/4 inch mesh. Roll it into a cylinder a couple feet long and about 5 inches in diameter. Lash a square piece securely to the bottom with wire. I start by dumping the brass and media in a regular brass pan thingy and spinning to get the bulk of cleaning media out of the brass, a tupperware bin catches the media. Then dump the brass in your wire cylinder and slowly bounce it up and down while the remaining media shakes out, then become more violent with the bounce as you go on. Sometimes I drop kleenex down into the brass and as I bounce, it works it's way through to the bottom pulling grit off the brass and builds a pad at the bottom of the cylinder. After about a 75 bounces the brass is pretty clean. I take the brass directly to the lube. No time consuming and boring wiping off.